diff options
Diffstat (limited to 'docs/fapi.txt')
| -rw-r--r-- | docs/fapi.txt | 33 |
1 files changed, 18 insertions, 15 deletions
diff --git a/docs/fapi.txt b/docs/fapi.txt index 698a0cb..67fe651 100644 --- a/docs/fapi.txt +++ b/docs/fapi.txt @@ -95,22 +95,12 @@ EXAMPLES Setting up a simple nPath Service A simple nPath service can be created as follows. - # Create a nPath HTTP vserver, 'nPath' also auto disables NAT and PAT - # fapi auto resolves the IP address. fapi vserver myvserver.example.com:80 create PROTOCOL_TCP nPath - - # Add the pool to the vserver. The vservers name inside of BigIP will be - # the FQDN followed by _PORT. In this case it would be: - # myvserver.example.com_80 (or full: /Partition/myvserver.example.com_80) - # The reason is that : are not allowed in vserver names. fapi vserver myvserver.example.com:80 set pool foopool - # Add a nPath HTTPS vserver - fapi vserver myvserver.example.com:443 create PROTOCOL_TCP nPath - fapi vserver myvserver.example.com:443 set pool foopool - - # Restrict the vserver to a specific VLAN (IMPORTANT! security + # Restrict the vservers to a specific VLAN (IMPORTANT! security # hole otherwise!) + fapi vserver myvserver.example.com:80 set vlan VLANNAME fapi vserver myvserver.example.com:443 set vlan VLANNAME # Put the VirtualAddress of the vserver into a specific traffic group @@ -128,11 +118,24 @@ EXAMPLES fapi node fooserver1.example.com delete fapi node fooserver2.example.com delete - Setting up simple NAT Services - (Docu to be written) + Setting up simple HTTP NAT Services + A simple HTTP NATed service can be created as follows. + + fapi vserver myvserver.example.com:80 create PROTOCOL_TCP /Common/http + fapi vserver myvserver.example.com:80 set vlan VLANNAME + fapi vserver myvserver.example.com:80 set pool foopool + + In order to make this work your application servers need to have setup a + default route to the loadbalancers floating self IP. Setting up simple SNAT Services - (Docu to be written) + Same as setting up a NATed services, but you don't need to configure + default routes from your application servers to the loadbalancers + floating self IP. + + You need also to set the SNAT flag as follows: + + fapi vserver myvserver.example.com:80 set snat automap About the NAME argument In most cases NAME can be a hostname, FQDN or an IP address. Optionally |