New release0.7.3

1 files changed, 3 insertions, 27 deletions

diff --git a/README.pod b/README.pod
index 163b025..225a5f6 100644
--- a/README.pod
+++ b/README.pod
@@ -107,22 +107,12 @@ If you want to list all configured objects on your partition just run
 
 A simple nPath service can be created as follows.
 
-  # Create a nPath HTTP vserver, 'nPath' also auto disables NAT and PAT
-  # fapi auto resolves the IP address.
   fapi vserver myvserver.example.com:80 create PROTOCOL_TCP nPath
-
-  # Add the pool to the vserver. The vservers name inside of BigIP will be
-  # the FQDN followed by _PORT. In this case it would be:
-  #  myvserver.example.com_80 (or full: /Partition/myvserver.example.com_80)
-  # The reason is that : are not allowed in vserver names.
   fapi vserver myvserver.example.com:80 set pool foopool
 
-  # Add a nPath HTTPS vserver
-  fapi vserver myvserver.example.com:443 create PROTOCOL_TCP nPath
-  fapi vserver myvserver.example.com:443 set pool foopool
-
-  # Restrict the vserver to a specific VLAN (IMPORTANT! security
+  # Restrict the vservers to a specific VLAN (IMPORTANT! security
   # hole otherwise!)
+  fapi vserver myvserver.example.com:80 set vlan VLANNAME
   fapi vserver myvserver.example.com:443 set vlan VLANNAME
 
   # Put the VirtualAddress of the vserver into a specific traffic group
@@ -144,24 +134,10 @@ And everything can be deleted as folows:
 
 A simple HTTP NATed service can be created as follows.
 
-  # Create a NATed HTTP vserver
-  # fapi auto resolves the IP address.
   fapi vserver myvserver.example.com:80 create PROTOCOL_TCP /Common/http
-
-  # Add the pool to the vserver. 
+  fapi vserver myvserver.example.com:80 set vlan VLANNAME
   fapi vserver myvserver.example.com:80 set pool foopool
 
-  # Add a NATed HTTPS vserver
-  fapi vserver myvserver.example.com:443 create PROTOCOL_TCP /Common/http
-  fapi vserver myvserver.example.com:443 set pool foopool
-
-  # Restrict the vserver to a specific VLAN (IMPORTANT! security
-  # hole otherwise!)
-  fapi vserver myvserver.example.com:443 set vlan VLANNAME
-
-  # Put the VirtualAddress of the vserver into a specific traffic group
-  fapi vip myserver.example.com set tgroup some-traffic-group
-
 In order to make this work your application servers need to have setup a
 default route to the loadbalancers floating self IP.